ARDESTO YCM-E1600 - MAKE HOT WATER; Methods

34
7. Pour the frothed milk into the espresso prepared; now the
cappuccino is ready. Sweeten to taste and if desired, sprinkle the
froth with a little cocoa powder.
8. Press the ON/OFF switch to the “0” position to cut the power
source o.
NOTE: we recommend you allow the maker to cool down at least for
5 min before making coee again. Otherwise burnt odor may occur
in your Espresso coee.
MAKE HOT WATER
1. With this function, you can pre-heat your coee cup to ensure
that the temperature of the coee will not decrease. So as to
improve the coee avor.
2. Clean your coee cup. After drinking coee, you can directly
make hot water with this coee maker to clean the cups. This
makes it more simple and convenient to clean the cups.
Methods:
1. Press the On/O switch to the “1” position; the Steam switch to “0”
position, Coee/hot water selector to “0” position. The red lamp
will be illuminated; waiting for a moment, the green lamp will be
illuminated.
2. First, turn the steam control knob from “OFF” to “0” position in
anti-clockwise. (Turn the knob with at least 135 degree.) Then
press coee/hot water selector to “1” position, and hot water will
ow out from the steam wand.
NOTE: At rst the hot water will scatter from the steam wand. May
let the steam wand outlet close to the coee cup wall. Thus at this
moment, you need to pay attention to the protection of hot water
splash burns skin.
EN