What to do if Ardisam Tiller engine misses or lacks power?
If the engine on your Ardisam Tiller misses or lacks power, try the following: * Raise the tines for shallow tilling by raising the depth regulator drag stake. * Clean or replace the air cleaner. * Replace the spark plug and adjust the gap. * Drain and refill the gas tank with fresh fuel. For improper carburetor adjustment, take the tiller to an authorized engine service center.
Why is my Ardisam Tiller engine hard to start?
If your Ardisam Tiller engine is hard to start: * Drain the old fuel and replace it with fresh fuel, and use a gas stabilizer at the end of the season. * Make sure the spark plug wire is securely attached to the spark plug. * Ensure the drive safety control lever is released to neutral to start the engine.
What to do if Ardisam Tiller makes a constant buzzing sound?
If you hear a constant buzzing sound while the engagement lever is compressed on your Ardisam Tiller: * Fully compress the engagement lever. * Properly space the wire guide from the idler pulley to clear the belt. * Check the belt tension and adjust if necessary. Note: If the buzzing persists after these steps, the belt may be stretched and need replacement.
Why Ardisam Tiller moves forward during starting?
If your Ardisam Tiller moves forward during starting: * Ensure the drive safety control lever is released to neutral to start the engine. * Check the belt tension.
What to do if Ardisam Tiller runs rough?
If the engine on your Ardisam Tiller runs rough or floods during operation, try cleaning or replacing the air cleaner.
Why Ardisam Tiller belts squeal?
If the belts squeal in forward operation on your Ardisam Tiller, check the belt tension and adjust it if necessary.
What to do if Ardisam Tiller has excessive heat build up?
If you notice excessive heat build-up in the transmission or tine area during tilling with your Ardisam Tiller: * Remove any vegetation. * Check the transmission fluid and fill if needed.
To Next Page
General