EasyManua.ls Logo

Ardisam Viper 212cc - User Manual

Ardisam Viper 212cc
24 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
Operator's Manual
Original Operating Instructions
Viper® 212cc
4-Cycle Engine
P/N: 13595
ECN: 10646
REV5: 111514
© 2014 ARDISAM, INC.
ALL RIGHTS RESERVED
GET PARTS ONLINE AT
WWW.ARDISAM.COM
GAS/OIL
RATIO
50:1
Product #: 13350

Questions and Answers

  • A
    Andrew StokesAug 1, 2025
    Why Ardisam Viper 212cc will not start?
    • N
      Nathan LewisAug 1, 2025
      Your Ardisam Engine might not start due to several reasons: the power switch could be off (flip the switch to the ON position), the fuel valve might be off (check and turn it on), the spark plug wire could be disconnected (connect it to the spark plug), the engine might be out of fuel (refuel), the spark plug could be wet, faulty, or improperly gapped (clean, replace, or gap the spark plug), or the battery could be discharged (recharge the battery).
  • D
    dnormanAug 7, 2025
    Why is my Ardisam Viper 212cc hard to start?
    • J
      Jessica BurchAug 7, 2025
      If your Ardisam Engine is hard to start, it could be due to stale fuel (drain the old fuel and replace it with fresh fuel, and use a fuel stabilizer at the end of the season), a loose spark plug wire (ensure the spark wire is securely attached to the spark plug), or a dirty carburetor (clean the carburetor and use fuel stabilizer with new fuel).
  • W
    wwatkinsAug 14, 2025
    What to do if Ardisam Viper 212cc Engine misses or lacks power?
    • A
      andreahernandezAug 14, 2025
      If your Ardisam Engine misses or lacks power, it could be due to a clogged fuel tank or fuel filter (remove and clean them), a clogged air filter (clean or replace it), improper carburetor adjustment, or a spark plug that is dirty, has an improper gap, or is the wrong type (replace the spark plug and adjust the gap to 0.030"). For carburetor issues, call the factory.
  • J
    jeffrey05Aug 19, 2025
    How to fix Ardisam Viper 212cc Engine that runs rough and floods?
    • C
      Christina WoodardAug 19, 2025
      If your Ardisam Engine runs rough and floods during operation, the issue might be a dirty air filter (clean or replace the air filter) or a choke that is partially engaged (turn off the choke). For carburetor adjustment issues, call the factory.
  • A
    Amber RobersonAug 25, 2025
    What to do if Ardisam Engine runs, then quits?
    • A
      Alexis WatkinsAug 26, 2025
      If your Ardisam Engine runs and then quits, the fuel cap might not be venting properly. Replace the fuel cap to resolve this.

Summary

WARNINGS AND SAFETY PRECAUTIONS

Owners Responsibility

Outlines the user's duty for safe assembly and use.

ENGINE SAFETY PRECAUTIONS

Preventing Carbon Monoxide Poisoning

Detailed advice to avoid carbon monoxide hazards.

Gasoline Fires and Handling Fuel Safely

HAZARD SYMBOLS AND MEANINGS

SAFETY DECALS

CONTROL AND OPERATING SYMBOLS

OPERATION

Pre-Operation Inspection

Steps to perform before starting the engine for safety and function.

Checking And Filling The Fuel Tank

Procedure for safely checking and adding fuel to the tank.

Checking and Adding Oil

STARTING AND STOPPING THE ENGINE

Engine Start

Specific steps and precautions for starting the engine.

To Stop the Engine

Procedure for stopping the engine using the switch.

Stopping the Engine with the Fuel Lever

Alternative method for stopping the engine using the fuel lever.

MAINTENANCE AND STORAGE

ENGINE MAINTENANCE

LUBRICATION

AIR FILTER

SPARK PLUG

FUEL FILTER

TROUBLESHOOTING AND REPAIR

TROUBLESHOOTING GUIDE

HIGH ALTITUDE OPERATION

ENGINE WARRANTY: 2-YEAR LIMITED EMISSIONS CONTROL WARRANTY

COMBINED EXHAUST AND EVAPORATIVE EMISSIONS CONTROL WARRANTY STATEMENT

Emission Warranty Parts List (D)

Ardisam Viper 212cc Specifications

General IconGeneral
BrandArdisam
ModelViper 212cc
CategoryEngine
LanguageEnglish

Related product manuals