Arduino Ethernet Shield 2 User Manual

2/2/2020 https://store.arduino.cc/usa/datasheet/index/index/url_key/arduino-ethernet-shield-2/
https://store.arduino.cc/usa/datasheet/index/index/url_key/arduino-ethernet-shield-2/ 2/2
Documentation
OSH: Schematics
Arduino Ethernet Shield 2 is open-source hardware! You can build your own board using the following files:
EAGLE FILES IN .ZIP SCHEMATICS IN .PDF
Previous Version
Do you own a past version of this product? Check the Arduino Ethernet Shield V1 product page.

Arduino Ethernet Shield 2 Specifications

General

Connection Speed	10/100 Mbps
Power Over Ethernet	No
Operating Voltage	5V
Ethernet Controller	W5500
Connection Type	RJ45
SD Card Slot	Yes
Compatibility	Arduino Uno, Arduino Mega
Network Protocols	TCP, UDP, ICMP, DHCP

Summary

Product Overview and Getting Started

Getting Started Guide

Information to configure the board, use the Arduino IDE, and start coding and electronics.

Support and Assistance Resources

Links to the Ethernet2 Library reference and Arduino Forum for project assistance.

Technical Specifications and Features

Details on the Ethernet controller, connectivity, micro-SD slot, reset, and optional PoE module.

Power over Ethernet (PoE) Module

Features of the optional PoE module designed to extract power from an Ethernet cable.

Onboard Status Indicators and Connectors

Description of LEDs for status and Tinkerkit connectors for analog I/O and TWI interface.

Documentation and Previous Versions

Open-Source Hardware Schematics

Links to download EAGLE files and SCHEMATICS in PDF format for building the board.

Previous Product Version

Information to check the Arduino Ethernet Shield V1 product page for past versions.