Arduino GY-NEO6MV2

_____________________________________________________________________________________
For purchase & enquiries, please contact sales@synacorp.com.my or call 04-5041617
Arduino GY-NEO6MV2 GPS Module c/w Antenna & Flight Control EEPROM
GY-NEO6MV2 board features the u-blox NEO-6M GPS module with antenna and built-in
EEPROM. This is compatible with various flight controller boards designed to work with a
GPS module.
Technical Specifications:
 Power Supply Range: 3 V to 5 V
 Model: GY-GPS6MV2
 Ceramic antenna
 EEPROM for saving the configuration data when powered off
 Backup battery
 LED signal indicator
 Mounting Hole Diameter: 3 mm
 Default Baud Rate: 9600 bps
 Module size 23mm * 30mm
 Antenna size 12 * 12mm
 Cable:20mm
Features:
 Use XM37-1612 module, MTK Platform, with high-gain active antenna
 TTL level, compatible with 3.3V/5V system
 The default baud rate: 9600
 With rechargeable backup battery, can save the ephemeris data when it power down,
and make the warm start.
 Suitable for RC quad copter, navigator

Arduino GY-NEO6MV2 Specifications

General

Model	GY-NEO6MV2
Chipset	U-blox NEO-6M
Frequency	L1, 1575.42 MHz
Update Rate	Up to 5 Hz
Interface	UART
Operating Voltage	3.3V - 5V
Dimensions	25mm x 35mm
EEPROM	Yes
Antenna	Built-in ceramic antenna
Communication Protocol	NMEA
Channels	50
Horizontal Position Accuracy	2.5 m
Navigation Sensitivity	-161 dBm
Acquisition Sensitivity	-148 dBm
Module Type	GPS
Sensitivity	-161 dBm
Baud Rate	9600

Summary

Technical Specifications

Power Supply Range

Specifies the voltage range for powering the module, from 3V to 5V.

Model Identification

Identifies the specific model of the GPS module as GY-GPS6MV2.

Antenna Type

Indicates the module uses a ceramic antenna for GPS signal reception.

Configuration Memory

Features EEPROM for saving configuration data when power is off.

Backup Power

Includes a backup battery for retaining data and enabling warm starts.

Mounting Hole Size

Specifies the diameter of the mounting holes as 3 mm.

Signal Indicator

Equipped with an LED signal indicator for GPS status.

Default Baud Rate

Sets the default communication speed to 9600 bps.

Module Dimensions

Provides the physical size of the module as 23mm x 30mm.

Antenna Dimensions

Lists the dimensions of the antenna as 12mm x 12mm.

Cable Length

Specifies the length of the attached cable as 20mm.

Module Features

Core Module and Antenna

Utilizes XM37-1612 module on MTK Platform with a high-gain active antenna.

System Compatibility

Offers TTL level interface, compatible with 3.3V/5V systems.

Baud Rate

The default baud rate is set to 9600.

Data Retention and Warm Start

Features a rechargeable backup battery to save ephemeris data on power down for warm starts.

Application Suitability

Suitable for RC quad copters and navigation systems.

Pinout Description

Power and Ground Connections

Details connections for VCC (3.3V/5V) and GND.

Serial Communication Pins

Specifies TXD to connect to MCU RX, and RXD to connect to MCU TX.