1
finger on top of the sensor.
You hear three short beeps
Ardwolf A10 Fingerprint Touchscreen Door Lock
Installation Instructions
Ardwolf A10 FINGERPRINT KEYPAD LOCK INSTALLATION
INSTRUCTIONS
Tools needed for new installation:
Pencil, Chisel, Tape Measure, Hammer, Phillips Screwdriver, 1” (25 mm) & ⅛” (3
mm) Drill Bits, 2 ⅛” (54 mm) Hole Boring Bit, Power Drill.
1. Mark door.
1.1 Mark centerline on door and jamb (see fig. 1).
1.2 Stand so door swings towards you.
2. Drill holes on door (see fig. 2, and 3), dimension 8 mm hole is optional.
3. Install Latch.
3.1 Latch is adjustable, you may set the latch to either
2 ⅜” (60 mm) or 2 ¾” (70 mm) backset (see fig.4).
3.2 Use faceplate as a pattern for mortise and pilot
holes. The faceplate should fit flush (see fig. 5).
3.3 Install as shown for appropriate latch type. Ensure
bevel faces doorjamb.
3.4 Check square hole edge on the latch spindle. The
square hole edges MUST are either parallel or vertically
aligned with latch centerline (see fig. 6), otherwise refer
fig. 7 to adjust latch spindle.
To Next Page
Need help?
General
