AREBOS Copenhagen - User Manual

Questions and Answers

T
Tiffany MosleyAug 2, 2025
Why is the AREBOS Spa Accessories heating system not working?
- E
  Emily StewartAug 3, 2025
  The heating system may not be working due to several reasons. The temperature might be set too low; ensure it's set higher (20 – 42°C) than the current water temperature. A dirty filter cartridge can also cause this, so clean or replace it. Check that the water level is correct and add water if needed. If none of these solutions work, the heating element may have failed, and further assistance is needed.
S
Sarah McdonaldAug 7, 2025
How to clean AREBOS Copenhagen water?
- M
  Marie CurtisAug 7, 2025
  If the water in your AREBOS spa is not clean, there are a few potential causes. You may need to increase the filtration time. Also, a dirty filter cartridge could be the culprit, so try cleaning or replacing it. Finally, ensure you are following proper water maintenance procedures, referring to the chemical manufacturer’s instructions for guidance.
S
Samantha ScottAug 11, 2025
What to do if AREBOS Copenhagen Spa Accessories filtering system does not operate?
- M
  Molly WoodsAug 11, 2025
  If the filtering system isn't working or you hear a rattling noise, it might be due to a dirty filter cartridge. Try cleaning or replacing it. If the problem persists, further assistance is needed.
M
Michael RodriguezAug 15, 2025
Why is my AREBOS Copenhagen Spa Accessories air jet system not working?
- C
  Carla SmithAug 15, 2025
  The air jet system might not be operating because the air pump is too hot or in cooling mode, or there may be something wrong with the power box. Try unplugging the system, letting the air pump cool down, then reinserting the plug and pressing the air jets button to activate. Wait 10 minutes and restart. If it still doesn't reset, further assistance is needed.
P
patrickpatrickAug 19, 2025
How to fix AREBOS Copenhagen leakage?
- C
  Christopher HunterAug 19, 2025
  If your spa is leaking, it may be torn or punctured. Use the repair patch provided to fix the leakage.
E
Elizabeth MccoyAug 25, 2025
Why is the AREBOS Spa Accessories display temperature too high?
- P
  Patricia KimAug 25, 2025
  If the display temperature is higher than 42°C after stopping the heating function, it could be due to residual water in the spa continuing to be heated. Unplug the spa from the mains and wait for the temperature to reduce and return to normal. Alternatively, the water inlet through the filter system may be blocked. Clean the inlet; if it doesn't reset, further assistance is needed.
C
Christopher LeeAug 29, 2025
How to fix the FC error on AREBOS Copenhagen?
- D
  David MoraAug 29, 2025
  The FC error appears when the filtration system has been working for approximately 168 hours. Check the filter and change it if necessary. Once done, press the filter button again to clear the error code and stop the warning tone.