10
5.2 Identification of the circuit breaker
Each circuit breaker is identified
by a name plate giving technical
details on its frame.
Each pole is identified by a
technical reference, either
engraved on a label glued to its
base, ...
or engraved directly on to the base
plate.
5.3 Identification of the circuit breaker with reduced pressure
A warning label specifies the
refill to its nominal pressure
stipulated on the name plate
(see § 5.2).
Warning label placed on each
pole.
ATTENTION
La pression interne de gaz a été ramenée à 0,5
bar pour le transport
Il est impératif de remettre l'appareil à sa
pression initiale avant sa remise en service.
Se référer à la plaque d'instruction
CAUTION
For transporting, the SF6 gas pressure has been
decreased to 0.5 bar
So it is absolutely vital to refill the pole to its
nominal pressure before commissioning.
Refer to name plate
ATENCION
La presion interna de gas a sido bajada a
0,5 bar para el transporte
Es imperativo de volver a inchar el apparato a
su presio inicial antes de su puesta en servicio.
Referise a la placa de instruccion
5.4 Handling the circuit breaker when unpacked
Comply with the special
instructions that may be
written on the device.
To Next Page
Loading...
