8
V 05/14
ASSEMBLY INSTRUCTIONS
Open the box and remove the 3 parts of the appliance: body, base and remote control unit.
1. Insert the base onto the lower part of the appliance and tighten the screws.
2. Stand the appliance up vertically on a level surface before switching on.
DESCRIPTION OF PARTS
1. Buttons and liquid crystal
display
2. Air delivery grille
3. Right side panel and intake
grille
4. Left side panel and intake
grille
5. Base
6. Remote control receiver
7. On/off button
FRONT VIEW SIDE VIEW REAR VIEW
HOW TO USE THE FAN HEATER
Position the unit on a flat, stable surface.
Connect the power cord to a suitable electric socket (220-240V~/50Hz).
On/off button (on the rear, between the body of the appliance and the base, below the side intake grilles)
Bring the on/off button to the “I” position. When the appliance emits a beep this means that the fan heater is ready for use.
Bring the button to the “0” position to switch off the fan heater.
Base
Unit
Screws
To Next Page
Loading...