Argo MINIMAL - Description of Parts; How to Install the Appliance

V 05/18
18
DESCRIPTION OF PARTS
1. Power switch
2. Control panel
3. Front panel
4. Cable
5. Foot
HOW TO INSTALL THE APPLIANCE
The convector can be used on the floor, after assembling the feet.
MONTARE I PIEDINI IN DOTAZIONE
A. Floor portable using: how to assemble the feet supplied
The convector is packed without feet. These must therefore be assembled before using the appliance.
Assemble the feet as shown in the figure and put the convector in an upright position. Position the unit on a flat,
stable surface and stop the wheels with the proper wheels locks before turning it on.
1. Turn the convector upside down and
loosen the wing nuts.
2. Insert the feet. The longest part
must be positioned behind on
the rear the convector.
3. Tighten the wing nuts on the feet.
5
2
1
3
4