How to reset Argo PURY BABY after filter replacement?
If the filter replacement reminder on your Argo Air Cleaner continues to flash after replacing the filter, press the Power button for 7 seconds to reset the machine.
What to do if my Argo PURY BABY smells like burning?
If your Argo Air Cleaner is emitting a burning smell, immediately unplug it from the power socket and contact a service center.
Why my Argo Air Cleaner is not working?
If your Argo Air Cleaner isn't working, start by checking that the power cord is securely plugged into the power socket. Also, verify that the power supply meets the rating requirements as indicated on the label. Inspect your home’s circuit breaker or fuses. If the filter indicator is flashing red, it means the filter needs replacement.
How to reduce noise from Argo PURY BABY?
If your Argo Air Cleaner is making significant noise, first check the fan for any obstructions. Ensure the machine is placed on a level surface. If the noise persists, set a lower wind speed, or use SLEEP wind speed at night in the bedroom.
What to do if my Argo PURY BABY Air Cleaner has poor performance?
To address poor performance in your Argo Air Cleaner, begin by cleaning the surface and pre-filter. Ensure there are no obstacles blocking the air inlet or outlet.
Instructions for powering on the air purifier and initial status indicators.
Details on how to turn the appliance on or off using the power button.
Explains how to cycle through and select wind speed modes (SLEEP, MID, HIGH).
Guide on setting the automatic switch-off timer for the purifier.
Instructions for cleaning the exterior of the air purifier with a damp cloth.
Guidance on cleaning the filter using a dry cloth and sunlight sterilization.
Information on when and how to replace the air purifier filter.
Recommendations for storing the appliance when not in use.
General| Brand | Argo |
|---|---|
| Model | PURY BABY |
| Category | Air Cleaner |
| Language | English |
To Next Page