OPERATING INSTRUCTIONS
NOTE: Before using the tool, read the
instruction book carefully.
INTENDED USE
The machine is intended for driving in and
loosening screws as well as for drilling in wood,
metal, ceramic and plastic.
CHARGING
1. CHARGING YOUR BATTERY PACK
WARNING: The charger and battery pack
are specically designed to work together
so do not attempt to use any other devices.
Never insert or allow metallic objects into your
charger or battery pack connections because an
electrical failure and hazard will occur.
2. BEFORE USING YOUR CORDLESS DRILL
Your battery pack is UNCHARGED and you must
charge once before use. When you charge the
new battery or one which has not been used for
long periods of time, it may not reach full charge
until after you have discharged it fully in use and
recharge it several times.
3. TO CHARGE THE BATTERY
(See Fig.A, B)
Insert the charger adapter (a) into a suitable
mains socket. And the red light (b) will illuminate.
Insert the Battery Pack(6) into the Charger base
(d). The green light (c) will on and the red light (b)
will remain on.
A discharged battery at normal ambient
temperature will take approximately 3-5 hours to
reach full charge. When charging is complete,
unplug the charger and remove the Battery Pack.
Note:
The charger will not automatically switch off when
the battery is full charged. Both the green light
and the red light indicator will remain on. Do not
leave your battery on charge continuously. This
may damage the battery cells.
Do not overcharge any batteries.
WARNING:After long usage the battery
will become hot. Let the hot battery cool
down for at least 0.5 hour before recharging.
4. TO REMOVE OR INSTALL BATTERY PACK
(See Fig.C)
Locate buttons on side of battery pack and
depress both sides to release battery pack from
your drill. Remove battery pack from your drill.
After recharge insert the battery pack into drill’s
battery port. A simple push and slight pressure
will be sufcient.
To Next Page
Loading...