waste authority for information regarding
available recycling and/or disposal options.
Discharge your battery pack by operating your
drill, then remove the battery pack from the drill
housing and cover the battery pack connections
with heavy duty adhesive tape to prevent short
circuit and energy discharge. Do not attempt to
open or remove any of the components.
PROBLEM SOLUTION
1. WHY DOES THE DRILL NOT TURN ON
WHEN YOU PRESS THE SWITCH?
The forward and reverse switch, which is on top
of the trigger, is positioned in the lock function.
Unlock the forward and reverse switch putting
it into the required rotation position. Push the
trigger and the drill will start to rotate.
2. THE DRILL STOPS BEFORE THE SCREW
IS COMPLETELY TIGHTENED. WHY?
Verify the torque position of the variable clutch,
you can nd the variable clutch between the
chuck and the drill body. Position 1 is the lowest
torque (screw driving force) and position 15 is
the highest torque (screw driving force). Position
is for drill operation. Regulate the variable
clutch to a higher position to reach the best
result.
3. I CANNOT FIT THE BATTERY INTO THE
BATTERY CHARGER. WHY?
The battery can be inserted into the charger only
in one direction. Turn the battery around until it
can be inserted into the slot.
4. REASONS FOR DIFFERENT BATTERY
PACK WORKING TIMES.
Charging time issues, as above, and having
not used a battery pack for a prolonged time
will reduce the working life of the battery pack.
This can be corrected after several charge and
discharge operations by charging & working
with your drill. Heavy working conditions such
as large screws into hard wood will use up the
battery pack energy faster than lighter working
conditions. Do not re-charge your battery pack
below 0°C and above 30°C as this will affect
performance.
MAINTENANCE
Your tool requires no additional lubrication or
maintenance.
There are no user serviceable parts in your
power tool. Never use water or chemical
cleaners to clean your power tool. Wipe clean
with a dry cloth. Always store your power tool
in a dry place. Keep the motor ventilation slots
clean. Keep all working controls free of dust.
Occasionally you may see sparks through the
ventilation slots. This is normal and will not
damage your power tool.
To Next Page
Loading...
