Revision V3 Jun 04
th
, 2014
Quick Reference Guide
Connecting Argox Cordless Scanner with Your
Smart Devices
Bluetooth HID
Argox offers additional connection solution with the AS-8020CL and AS-8520
cordless imagers. The new Bluetooth HID feature for these two models provides the
ability to connect other Bluetooth devices, for example, smartphones, tablet PCs,
iPod, iPhone, iPad,… which require HID protocol to pair with. This feature resolves
the previous problem that AS-8020CL and AS-8520 can only connect with other
devices via the SPP protocol.
AS-8020CL AS-8520
The Bluetooth HID only applies to these models:
Note: Even though the user owns the mobile device with one of the above
said OSs, it may still fail to connect with new AS-8520 and AS-8020CL
because the mobile device does not support HID connectivity in their
official released firmware.
Connecting with Apple iOS devices (iPod, iPhone, iPad)
1. Power off the cradle
2. Set the PIN code to 0000 assigned to the target Bluetooth device
3. Make sure the battery in the AS-8020CL
or AS-8520 is fully charged.
4. Scan “iOS HID” barcode:
5. Power on your Apple device and run
“Settings”. Go to “General” – “Bluetooth”
and turn the Bluetooth On. Then the Bluetooth device searching will start.
6. Your Apple device will find Argox Cordless Scanner “AS8520 XXXXXXXXX” or
“AS8020CL XXXXXXXXX” under the status of “Not Paired”.
7. Click the found device and you will hear three beeps after certain connecting
time. The status will be changed to “Connected”. Now your Argox Cordless
Scanner successfully connects with your Apple device.
To Next Page
Need help?
General
