To Next PageTo Next Page
Need help?Do you have a question about the Argox AS-8520 and is the answer not in the manual?
General| Brand | Argox |
|---|---|
| Model | AS-8520 |
| Category | Laboratory Equipment |
| Language | English |
Connect the AS-8520 to a PC using a Bluetooth USB dongle for wireless data transfer.
Configure the scanner's PIN code to '0000' for Bluetooth pairing with the device.
Instructions to establish a wireless link between the imager and its charging cradle.
Procedure to disconnect the imager from the cradle and put it into Deep Sleep Mode.
Details on charging the imager's rechargeable battery and LED indicators.
Step-by-step guide for replacing the imager's internal battery.
Configure automatic updates for firmware and/or settings between imager and cradle.
Manage the imager's power-saving Deep Sleep Mode durations.
Enable automatic detection for cradle or other Bluetooth devices.
Configure the cradle's inquiry beep behavior (disable, frequency).
Adjust the beep loudness level of the cradle from off to level 7.
Configure the host interface type (Keyboard Wedge, RS-232, USB).
Settings for keyboard wedge emulation, layout, and speed.
Settings for RS-232 communication, including flow control and delays.
Configure scanning behavior like Good-read off, Momentary, Alternate, Timeout off.
Define global minimum and maximum code lengths for barcode reading.
Status indications for the imager via LEDs and beeper.
Status indications for the cradle via RF and Battery LEDs.
Configure UPCA barcode read function, transmission, and ID settings.
Define a character to represent the symbol upon a succeeding reading.
Define prefix or suffix characters transmitted with scanned data.
Configure preamble or postamble characters to append to data automatically.
Configure insertion of up to two groups of 22 characters into transmitted data.
Display the current firmware versions of the cradle and imager.
Return the imager and cradle to their default factory settings.
