S
steven09Aug 21, 2025
What to do if my Argox Barcode Reader shows 'Paper Jam'?
- CchadgriffinAug 21, 2025
If your Argox Barcode Reader displays a 'Paper Jam' error, you should recover the jam.
To Next PageTo Next PageWhat to do if my Argox Barcode Reader shows 'Paper Jam'?
If your Argox Barcode Reader displays a 'Paper Jam' error, you should recover the jam.
What to do if my Argox Barcode Reader is in PAUSE status?
If your Argox Barcode Reader is in PAUSE status, press the FEED button to resume printing.
What to do if my Argox Barcode Reader displays 'Ribbon Out'?
If your Argox Barcode Reader indicates 'Ribbon Out', install a new ribbon roll. Alternatively, if you do not require a ribbon, set the printing mode to “Direct Thermal” via the driver or commands.
What to do if my Argox Barcode Reader displays 'Media Out'?
If the Argox Barcode Reader shows a 'Media out' error, install a new label roll.
What to do if the cutter has failed, or there is a paper jam inside the cutter of my Argox Barcode Reader?
If the cutter has failed or there is a paper jam inside the cutter of your Argox Barcode Reader, check the cutter and recover any paper jam.
Why is my Argox Barcode Reader not indexing label gaps?
If your Argox Barcode Reader is not indexing label gaps, check the label path and the label sensor. If you are using a continuous label roll, configure the driver settings or commands to use “continuous media” printing.
What does it mean when my Argox Barcode Reader says 'Printer is receiving data'?
When your Argox Barcode Reader displays 'Printer is receiving data', it means that the device is currently processing information. As soon as all data has been received, the Ready LED will stay solid green, and normal operation will automatically resume.
How to fix 'Serial IO error' on my Argox Barcode Reader?
To resolve a 'Serial IO error' on your Argox Barcode Reader, check the serial baud rate settings on both your system and the printer to ensure they match.
What to do if my Argox Barcode Reader shows 'Print head needs to cool down'?
If your Argox Barcode Reader displays 'Print head needs to cool down', printing will stop until the print head cools to a normal printing temperature. Once it completes, the printer will automatically resume the printing tasks sent previously.
What to do if the printer head module is unlatched on my Argox Barcode Reader?
If the printer head module is unlatched on your Argox Barcode Reader, close the printer module and then press firmly on both the left and the right sides of the printer module to properly latch it.
General
