Argus 300 - Previewing Live Video; Recording Video Clips; Playback Recorded Video

0 replace the lamp, loosen the
Tastee
ike
seal
te
haoe
howting and lle i of The k
the bayonet-type, Life off metal
‘rl down and turn
counter <lockwie to ee
inove. Place new lamp in position
By locating tgs in slot of sock.
The
ARGUS
300
Projector
uses
the
standard
300
Watt
T-81g
C-13
filament
lamp,
single
contact,
bayonet
base.
Projector
operates
nly on $0-60 cycle, A.C. current
Keep a spare lamp on hand, It
should
be
replaced
periodically
when
it
becomes
blackened
from
use
in
order
to
keep
the
projector
brillance
at
its
peake
This will
wre
maximum
efficiency
and
greater
enjoyment
from
projecting
your slides.
remove. condensers for
cleaning, “frat “remove the
Jannp ‘housing’ aa for replacing
the. lamp. Then remove the
spring.
ateel
“locking
device,
‘which
holds
the
condensers
se:
Curely
in
position,
by
separating
the
corners
THE condensers can now be
lifted out, "Before removing,
rote careluily their positions
Be sure to replace them in the
original “positions. “with each
Curved sufface facing as before.
OTE: To. clean use lens
tissue, a Fintless cloth or a camel
hhair ‘brush to avoid scratching
the lens surfaces,