Three
other
Argus comeros
use the some shutter
design os
we find
in the C-4.
The Argus 2l
iust
locks the
built-in
rongefinder.
The Argus
C-44
odds
the feoture
of inter-
chongeoble lenses;
ond the Argus
C-44R, the top
of the
line, reploces the
wind knob wifh the
more-convenient
ropid-wind
lever.
REMOVING
THE
ARGUS C-4 SHUTTER ASSEMBLY
Reoching the
built-in
Argus
C-4
shutter
involves o
very
stroightforword
disossembly.
So
we'll
iust
outline the
procedure
here.
First, remove the screw holding the wind knob. Lift off
the
wind knob
ond tokeout
the two screws
holding
thewind knob
seot
(underneoth
the wind knob).
You
con now lift off the wind
knob
seot ond
the bross wind
shoft
with its compression spring.
Tokeoff
the
rewind knob
byremoving itscenterscrew.
Now
toke out the two screws
holding the spoceroround
the
rewind shoft.
One screw holds the film
counter
diol.
Remove
the
screw
ond lift off
the diol--the wosher
ond compression spring, sitting
underneoth the
film
counter
diol
(with
the wosher
on top of the
spring)
con then
be removed.
Lift the top
cover
plote
high
enough to see
where the
sync
wires ore soldered,
Fig. 27.
Note
the posiiions
of the wires
by
fheir color
codes
--then,
unsolderthe
threewires ond remove lhe
top cover plote. Lift
off the loose spocer which sits
oround the
rewind shoft, Fig. 27.
UPPER
GEAR
TRAIN
ASSEMBLY
SPACER
AROUND
REWIND
SHAFT
GREEN
WIRE
(M]
WHITE
wtRE
(x)
BLACK
WIRE
(coMMoN)
FIGURE 27
22
To Next Page
Loading...
