Argus C3 - Page 23

NOTE: On
reossembly,
you'll
hove toodiust
the lens
tor
proper flocus. Although lens focusing
procedures ore
covered loter
in
your course/ we'll describe
the
procedure
for the C-4 in this text.
Thepin
screwyou
iust
removed keys
intoo
slot
in
the focusing
ring.
And the focusing ring
geors
to
the RANGEFINDER DISC,
Fig.
26.
For
reossembly reference
on the
timing
between
the
focusing ring ond fhe rongefinder disc,
set
the rongefinder
disc
to the infinity
position. Notice
thqt the
lost tooth ot the
left-
hond
endof
the focusing ringgeored
rocknowengoges
the
ronge-
finder
disc
--thot
is,
when the infinity
colibroiion
on the ronge-
finder disc oligns
with the index dot
on the comero
front
plote.
Remove
the
retoining ring
thot holds
the focusing ring in
ploce.
Now,
lift off
the focusing ring.
You must
peel
bock the
front leotherette
on eoch
side of the
lens mount to
reoch the fourscrews
holding the
comero
froni plote
ossembly.
You'll
f ind, however,
thot it's often diff
icult to
remove
the leotherette without
domoge
--even
though
you're very
core-
ful. So
if
youdo rnuchArgus
C-4work,
you
might
find
itdesiroble
to keep
some new leotherette
in
stock.
After removing
the
front leotherette,
ioke out the
four front
plofe
retoining screws. Then,
lift out the complete
front
plote/-
shutter ossembly os one unit.
Figure 29
shows the
front
plote/shutter
ossembly
removed
from
the
comero body.
FIGURE
24
29
FRONT PLATE/SHUTTER ASSEMBLY