20
Compute
r does not recognize camera for
Windows 98SE, The camera driver has to be
installed before picture download. In picture
preview mode, ensure that USB mode is set to
MSDC before connecting the camera to the
compute
r. For Windows 2000/ ME /XP, the
camera is recognized as a plug -&-playable,
removable flash disk without driver installation
under MSDC mode. It is
recommended that you
disconnect your digital camera f
rom your
computer after use.
Flash will not fi
re
Flash set to OFF -Set the flash to
Auto or On.
Flash has not been fully cha
rged The flash takes
a few seconds to cha
rge up while the Operation
LED is blinking. Flash light is fully cha
rged
when the Operation LED turns o
ff.
Battery level is low -
When the battery indicator
does not show a fully cha
rged battery, the
voltage is too low for the flash to work. Please
Image is blur
red / out of focus
Subject is out of focal range. Ensure that there
is at least 1.5m ( 5ft ) between the camera lens
and subject. Camera moved during the shot-
Hold the camera steady while taking the picture.
When flash is on, hold the camera steady until
flash has fired twice(
The first flash is to reduce
red-eye and to detect the brightness of the
change batteries.
ta
rget.)
To Next Page
Loading...
Need help?
General
