Carefully unpack all parts and identify them with parts list and
assemble the chair following the Assembly Instructions.
Put the chair onto a flat floor then you can sit onto and adjust the
reclining and the seat height
1.Please sit down onto the chair and use the left handle (A) to adjust the
reclining of the chair, and use the right handle (B) to adjust the height of
it.
2. Pull the left handle (A) out and the chair is active to recline .Get a
desired tilt and release the left handle to lock it. You can lock at several
different tilt angles by reclining your body.
3. Turn the right handle (B) upward to activate the cylinder for adjusting the
height of the chair. Raise your body up, the seat will be lifted up to a
desired height by the cylinder. To get a lower height, please sit down
with the right handle (B) turning upward. Release the right handle (B) to
lock the cylinder when you achieve a desired seat height.
4.Turn the knob(C) clockwise to lessen the tension and counter clockwise
to tighten the tension
To Next Page