ARHAUS Addy - Page 96

Step 1 :
stretcher and bottom front rail .
- Firmly tighten Bolt using Allen Key ( D )
- Note : To aid in placement, do not fully tighten Bolt until all are threaded in to place.
Step 2:
- If the Desk is uneven, adjust the levelers on the bottom of each leg ( G ) by twisting them
clockwise or counter clockwise until the Desk is even.
E
F
G
F
D
A
C
B
D
A
C
B
G
F
Page 2 of 2
- Reverse Top assembly for the leg assembly preparation.
- Place leg assembly on Apron end of the Desk Top with pre-fitted Stretcher.
- Assemble allen Bolt ( A ), Spring washer ( C ) and Flat washer ( B ) and use to attach leg
assembly to the Desk Top.
- Assemble allen Bolt ( A ) Spring Washer ( C ) and Flat Washer ( B ) and use to attach
96