Aries 1501278 User Manual

PAGE 1 • 1501278-INS-RB • 877.287.8634 • NEED ASSISTANCE? • ARIESAUTOMOTIVE.COM
Product Image
Level of Difficulty
Easy
Scan
for helpful
install tips
INSTALLATION MANUAL 1501278
Wiring Diagram
Notes and Maintenance
Before you begin installation, read all instructions thoroughly.
Periodic inspection of all wires and connections should be performed to ensure
there is no visible damage or loose connections.
WARNING: Improper electrical installation may damage electronic components
resulting in personal injury, property or equipment damage. Damaged caused
by incorrect installation is not covered by warranty. Installation should only be
performed by qualified personnel with asolid understanding of electrical systems.
Parts List
1 LED light bar, 50"
1 Mounting bracket, left
1 Mounting bracket, right
1 Wiring harness
2 Security screw,
M6 - 1.0 x 25mm
2 Rubber spacer, M6
2 Flat washer, M6
1 Security screw L-wrench
1 30 amp fuse, pre-installed
Step 1
Mount the LED light in the desired
location with a rubber spacer between
the mounting surface and each bracket.
Note: If this light bar is being used
with a 24V system, the relay will need
to be replaced with a 24V unit.
Disconnect the supplied switch
from the wiring harness and install
in the desired location.
Step 2
Once the LED light bar and switch are
installed, route the wiring harness to
the light. Insert the male plug on the
wiring harness into the female socket
on the LED light. Reconnect the blue,
red and black spade connectors to
the switch (see the wiring diagram).
Step 3
Connect the red fused wire with
the ring terminal to the positive (+)
battery post. Connect the black
wire ring terminal to the negative (-)
battery post or other suitable vehicle
grounding point.
Step 4
Mount the provided relay to the
vehicle and secure all wires with zip
ties away from moving parts to avoid
damage. Test the light to ensure
proper function.

Aries 1501278 Specifications

General

Brand	Aries
Model	1501278
Category	DJ Equipment
Language	English

Summary

Parts and Overview

Parts List

Lists components for installation: LED light bar, mounting brackets, wiring harness, security screws, spacers, washers, and fuse.

Product Image

Visual representation of the 50" LED light bar.

Installation Steps

Step 1: Mount LED Light

Mount the LED light using rubber spacers between the mounting surface and brackets. Disconnect and relocate the switch.

Step 2: Route Wiring

Route the wiring harness to the light, connect the male plug to the LED socket, and reconnect spade connectors to the switch.

Step 3: Connect to Power

Connect the red fused wire to the positive battery post and the black wire to the negative battery post or a suitable ground.

Step 4: Secure and Test

Mount the provided relay, secure all wires with zip ties away from moving parts, and test the light for proper function.

Wiring and Dimensions

Wiring Diagram

Illustrates the connection of the LED light bar, switch, relay, fuse, and battery.

Basic Dimensions

Provides detailed measurements for the LED light bar and mounting brackets.

Mounting Illustration

Visual guide showing the physical mounting of the brackets and light bar.

Safety and Maintenance

Notes and Maintenance

Read instructions thoroughly. Periodically inspect wires and connections for damage or looseness.

WARNING: Electrical Installation

Improper installation may damage components, cause injury, or void warranty. Use qualified personnel.