Aries 2500201 User Manual

Notes and Maintenance
Before you begin installation, read all instructions thoroughly.
Proper tools will improve the quality of installation and reduce the time required.
To protect the product, wax after installing. Regular waxing is recommended
to add a protective layer over the finish. Do not use any type of polish or wax
that may contain abrasives that could damage the finish.
For polished, gloss and other smooth finishes,
polish may be used to clear small scratches and scuffs on the finish.
Mild automotive detergent may be used to clean the product.
Do not use dish detergent, abrasive cleaners, abrasive pads,
wire brushes or other similar products that may damage the finish.
Refer to the table to the left when securing hardware during the
installation process to help prevent damage to the product or vehicle.
Torque Specifications
METRIC
M6 bolt 3 ft.-lbs.
M8 bolt 7 ft.-lbs.
M10 bolt 16 ft.-lbs.
M12 bolt 28 ft.-lbs.
SAE
1/4" bolt 3 ft.-lbs.
5/16" bolt 7 ft.-lbs.
3/8" bolt 16 ft.-lbs.
7/16" bolt 20 ft.-lbs.
1/2" bolt 28 ft.-lbs.
Use above torque setting
unless otherwise noted
PAGE 1 • 2500201-INS-RF • 800.798.0813 • NEED ASSISTANCE? • ARIESAUTOMOTIVE.COM
Level of Difficulty
Moderate
Scan
for helpful
install tips
INSTALLATION MANUAL
Parts List
1 Driver-side fender flare
1 Passenger-side fender flare
16 Hex bolt, M6 x 20mm
16 Rivnut, M6
17 Flat washer, M6
16 Lock washer, M6
1 Insert tool, M6
1 Left hand nut, M8
1 Metal spacer
Tools Required
Ratchet Socket, 10mm
Wrench, 13mm Socket, 13mm
Drill Cut-off tool
Plier-style thread
set tool, M6
Drill bit,
25/64" OR 10mm
Paint marker Trim removal tool
Product Image
2500201

Aries 2500201 Specifications

General

Brand	Aries
Model	2500201
Category	Car Spares
Language	English

Summary

Parts List

Tools Required

Torque Specifications

Notes and Maintenance

General Installation and Care

Read instructions thoroughly. Wax after install for protection. Use mild detergents; avoid abrasives.

Installation Steps

Step 1: Remove Stock Fender Flare

Remove push-in retainers and hex bolts to detach the original fender flare.

Step 2: Position and Mark

Align the new fender flare and mark mounting locations on the vehicle body.

Step 3: Drill New Mounting Holes

Drill new holes (25/64" or 10mm) if factory holes do not align, ensuring correct size for rivnuts.

Step 4: Prepare Rivnut Tool

Assemble the rivnut tool with the left-handed nut, spacer, flat washer, and rivnut.

Step 5: Install Rivnuts

Insert rivnut and use the tool to compress it into the drilled hole without over-tightening.

Step 6: Trim Inner Fender Flare

Place the plastic inner fender flare, mark for trimming, cut carefully, and check fit.

Step 7: Mount Fender Flare

Lift the ARIES fender flare into place and thread the supplied hardware.

Step 8: Reinstall Inner Fender

Reinstall the inner fender well using stock hardware, with optional zip ties for a tight fit.

Step 9: Tighten Hardware

Tighten all hardware using a 10mm socket and repeat the process for the passenger side.

Step 10: Final Inspection

Confirm all mounting hardware is tight and refer to maintenance section for ongoing care.