ARIETE Evolution 2.0 - Using the Robot; Direct Charging via Adaptor

-26-
EN
INsTRUCTIONs FOR UsE
 PLACETHE CHARGINGSTATION(I)

      

 


 
        

 TURNTHESWITCH(Q)

Important!
IftheRobotisconnectedtothemainspowerwithoutrstswitchingitonattheONbut-
ton,thedisplaywillshowthe“E10”errorcode,theicons2-3-5-6willstarttoashand
anintermittentacousticsignalwillbesoundedtowarnthatnocharginghastakenplace.
 CHARGETHEBATTERY:
 
 
a) Directly via adaptor (F)
 

Important!
NeverusethischargingmethodswhentheRobothasbeensettoswitchonlaterforcle-
aning(seethe“Programming”chapter),asthiscouldcausedamagetothepowercord
andtotheapplianceatthestartofthecleaningcycle.
1 m
1 m
2 m