38 /GB
4.3 Installation of gateway on the boiler
WARNING!
you should clean the surface thoroughly
1. Stick the double-sided tape to the back
of the support plate (Figure 7); remove
the protective film and attach to the
boiler;
2. Attach to the plate, pressing along the
sides (Figure 8);
3. Attach the cover, pushing gently (Figure
9).
NOTE:
In order to avoid interference problems,
The following versions of the Ariston
Sensys software are not compatible with
Ariston Net:
If this is the case, replace the existing
Sensys with the one supplied in the
7
8
9
To Next Page
Loading...
