1 2
14 - GB
• Check that the connection between the
receiver and the heat generator has
been completed successfully (green
led on) as indicated in the receiver's in-
struction booklet .
• Check that the wireless multizone kit is
powered up (green led on). (Fig. 8)
• Hold the key on the multizone radio
module down for 3 seconds; the radio
module's red led (Fig. 7) and the leds
on the wireless multizone kit (Fig. 8) will
start fl ashing.
• Hold the key on the receiver down for
5 seconds; the red led will fl ash 3 times
in 1 second and then go out.
The association procedure now starts.
• If the association procedure is success-
ful, the receiver's led will go out and the
wireless multizone kit leds for the out-
puts connected to the accessories will
turn on.
associating the wireless device
Multizone radio module
LED STATUS DIAGNOSTICS
GREEN
OFF Controller not powered up or system reset
ON Controller powered up
RED
OFF Device associated
Flashing Association procedure running
ON Device not associated
Wireless multizone kit
LED STATUS DIAGNOSTICS
RED
OFF Output inactive
Slow fl ashing Device association in progress
ON Output active
DIAGNOSTICS
RED LED GREEN LED
BUTTON
Fig. 7
Fig. 8
LED
To Next Page
Loading...
