Ariston AT 84 - User Manual

Questions and Answers

J
johnsonmeganAug 4, 2025
Why Ariston AT 84 Washer won't start?
- C
  Christina MurphyAug 4, 2025
  If your Ariston Washer fails to start, several factors could be at play. First, ensure the plug is correctly inserted into the socket and that there is electricity in your house, as a tripped circuit breaker might be the cause. Check that the appliance door is properly shut, as the washer won't start if the door isn't closed correctly. Also, verify that the ON/OFF button is pressed, and if your model has a programmed start knob, ensure it's in the correct position. Finally, check that the water tap is turned on, because the washing machine cannot start a wash cycle if it does not load water for safety reasons.
K
Kerri KennedyAug 11, 2025
How to reduce vibration of Ariston Washer during spin cycle?
- D
  donald83Aug 11, 2025
  If your Ariston Washer vibrates too much during the spin cycle, it could be due to several reasons. Make sure the internal floating unit was correctly unblocked during installation. Also, ensure the washing machine has been leveled correctly, as it may move imperceptibly over time. Check that the metal ring of the inlet hose and the drain hose are properly attached. An obstructed detergent dispenser could also cause excessive vibration.
J
James HendricksAug 19, 2025
What to do if Ariston AT 84 Washer does not drain or spin?
- M
  mmarquezSep 12, 2025
  If your Ariston Washer does not drain or spin, ensure that the selected programme is suitable for washing-machine use. Check if the “Anti-crease” function has been enabled. Verify that you are using the correct amount of detergent, as an excessive amount can cause problems. Also, check if the drain pump is clogged.
E
Evan TaylorAug 27, 2025
Why Ariston AT 84 Washer continuously loads and unloads water?
- T
  Toni BrownAug 27, 2025
  If your Ariston Washer continuously loads and unloads water, check if the drain hose is positioned too low; it should be installed at a height ranging from 60 to 100 cm. Also, verify that the hose’s mouth is not immersed in water. If the problem persists, the wall drainage system may have a problem with its breather pipe.