41
GB
visualisation.
Turn the knob and select:
- 3 3 3 Pro-Tech anode active
Press the OK button.
Turn the knob and set the value as indi-
cated in the manual or instruction sheet
accompanying the electronic PCB spare
part.
Press the OK button.
The display will visualise the selected set-
ting.
Press OK button to return to the previous
visualisation.
Turn the knob and select:
- 3 6 2 Tank capacity
Press the OK button.
Turn the knob and set the value as indi-
cated in the instruction manual accom-
panying the PCB spare part.
Press the OK button.
Turn the knob and set the value as indi-
cated in the manual or instruction sheet
accompanying the electronic PCB spare
part.
Press the OK button.
The display will visualise the selected set-
ting.
Press OK button to return to the previous
visualisation.
Press the back “
“ button to return to the
previous screens or to exit the solar con-
fi guration section.
The error log can be checked through the
Errors menu.
Simultaneously press the back “
“ and
“OK” buttons until “Enter code" appears on
the display.
Turn the knob to enter the technical code
(234) then press OK; the display will visual-
ise TECHNICAL AREA.
Turn the knob and select:
- FAULTS
Press the OK button.
Turn the knob and select:
- Solar controller
Press the OK button.
Turn the knob to scroll through the last 10 er-
rors recorded by the system on the display.
start-up
To Next Page
Loading...