ARISTON DISHWASHER - Instructions for installation and use
#
D
1509)50-4
Detergent and rinse aid
The rinse aid.
This product makes dishes
sparkle more as it improves
their drying. The rinse aid
container is situated on the
inside of the door: It should
be filled up when the low
rinse aid indicator light "T"
flashes.
Loading the rinse aid.
To open the dispenser, turn
cap C anticlockwise. Take
care when you pour in the
rinse aid to avoid it
overflowing. You can adapt
the amount of rinse aid used
by the dishwasher: regulate
the adjuster F which you will
find under lid C. You can
choose from six different
positions.
The detergent
Loading the detergent
To open lid A, press button B.
The detergent should be
poured into the two
containers C and D up to the
rim.
Now you can close the lid:
press it down until you hear
it click.
If you prefer to use the
detergent in tablet form, then
place one inside the
container D and close the
lid.
It won't close!
Check whether there is any
detergent residue on the
edges of the dispenser. It is
due to this residue that the
lid won't close. Get rid of it
and you'll see that it closes.
Only use specific dishwasher detergents. Pour the detergent into the dispenser
on the inside of the door. Before the wash cycle starts!
Use the right
amount of
detergent: if you
use too much,
you will not get
cleaner dishes,
but just more
environmental
pollution.
Keep your
dishwasher
detergent and
rinse aid in a
cool, dry place
and away from
children.
Useful tips
You can choose from six different
positions. It is normally set to 4.
Warning
Three-in-one dishwasher tablets are now available on the market, and combine detergent, salt and rinse aid all in one.
If the water in your area is hard or very hard, we still recommend you pour extra salt into the relevant dispenser to prevent the
formation of white streaks on your dishes or on the interior of the appliance.
Using a three-in-one product means it is no longer necessary to put rinse aid into the relevant container.
If you want to achieve perfectly dry dishes, you may add rinse aid as long as the dosage adjuster is set to no.2.
In any case, please read the manufacturer's instructions on the packet.
If you use only these products, it is normal for the salt and rinse aid indicator lights to flash permanently after a certain number
of cycles.
Proper dosage of
the rinse aid
improves drying.
If drops of water
remain on the
dishes or spotting
occurs, turn the
dosage adjuster to a
higher setting.
If, on the other
hand, the dishes
have white streaks,
then turn the
dosage adjuster
down to a lower
setting.
To obtain the best results from each washing and drying
cycle, powder detergent, rinse aid liquid and salt should be
used.
To Next Page
Loading...
