The washing machine
does not drain or
spin.
Does  the  selected
programme incorporates
water  draining?  Some
programmes stop at the end of
the wash cycles and draining
will  have  to  be  selected
manually.
Is  the  Rinse-Hold"
function -where provided -
enabled?  This  function
requires manual selection for
draining.
Is the drain hose kinked?
The tract of the drain hose
must be as straight as possible.
Make sure the drain hose is not
squashed or kinked.
Is the washing machines
drain duct clogged? Is there
an  extension  of  the  drain
hose? If so, is it positioned
incorrectly, blocking the water
flow?
Excessive  vibration
during the spin cycle.
Have all transit screws been
removed  durind  instal-
lation?  See  the  following
page  on  installation
procedures.
Has the washing machine
been levelled correctly? The
levelling  of  the  appliance
should  be  checked
periodically. Adjust the feet
and check them with a level.
Is there space between the
machine and adjacent units?
If it is not a built-in model, the
washing machine will oscillate
a bit during the spin cycle. A
few  cm  of  space  should
therefore be left around it.
The washing machine
leaks.
Is the metal ring of the inlet
hose properly attached? Turn
off  the water supply, unplug
the  appliance  and  try
tightening  its  attachment
without forcing it.
Is the detergent dispenser
obstructed?  Remove  and
wash it under tap water.
Is  the  drain  hose  well
attached? Turn off the water
supply, unplug the appliance
and  try  tightening  its
attachment.
Too much foam.
Is the detergent appropriate
for machine washing? Check
whether the definition on its
label reads for machine wash
or hand and machine wash,
or any other similar wording.
Is the correct amount being
used? An excessive amount of
detergent, besides producing
too  much  foam,  does  not
guarantee a more effective
wash, and causes scaling in the
internal parts of the appliance.
If,  despite  all  checks,  the
washing  machine  fails  to
function  and  the  problem
persists, call  your  nearest
authorised Customer Service
Centre, providing the following
information:
- the nature of malfunction
- the model type no. (Mod. ....)
-   the serial number (S/N ....)
This information can be found on
the data plate situated at the back
of the washing machine.
Technical characteristics
Always  get
assistance  from
authorised
technicians  and
always  insist  on
original  spare
parts.
9  Margherita 2000 - Instructions for installation and use
M
ARGHERITA
2000
Model
AB 65 X
Dimensions
width 59,5 cm
height 85 cm
depth 53,5 cm
Capacity
from 1 to 5,5 kg
Electrical
connections
voltage 230/240 Volt 50-60 Hz
maximum absorbed power 1850 W
Water
connections
maximum pressure 1 MPa (10 bar)
minimum pressure 0,05 MPa (0,5 bar)
drum capacity 46 litre
Spinning speed
up to 600 rpm
Control programs
in compliance
with IEC
regulation 456
carried out with 5, 0 kg load
This appliance conforms with the following E.E.C. directives:
- 73/23/E EC of 19/02/73 (Low Voltage) and subsequent modifications
- 89/336/EEC of 03/05/89 (Electromagnetic Compatibility) and subsequent modifications