NA
23
Display messages
Display messages
The machine’s display informs the user of how it is to
be used.
Here is a list of the alarm messages that prevent
coffee brewing and what the user should do to solve
the problem.
STANDBY
• Press the key.
READY FOR USE
DECALCIFY
• Descale the machine.
FILL WATERTANK
• Fill the water tank with fresh drinking water.
! The machine requires the tank to be filled even when
the level is still high. This happens because the tank
of the coffee machine has been preset to house the
optional “water filter”, thus requiring a minimum level of
water in the tank for filtering to be performed.
COFFEE BEANS EMPTY
READY FOR USE
• Fill the container with coffee beans and start the
coffee brew cycle.
WASTE TRAY FULL
• Open the door, remove the dregs drawer and empty
the dregs into a suitable container.
! Important note: The dregs drawer must only be
emptied when the machine is switched on. The dregs
drawer must be removed for at least 5 seconds. If the
drawer is emptied when the machine is switched off, it
will not be possible to brew coffee when switched back
on.
BREWUNIT MISSING
• Insert the brew group correctly.
WASTE TRAY MISSING
• Insert the drip tray and the dregs drawer correctly.
CLOSE DOOR
• Close the front door.
CLOSE CONTROL PANEL
• Close the upper panel.
VENTILATE
• Place a cup or suitable container below the steam
spout and press the
key.
Wait until the water runs smoothly out of the steam
spout.
To interrupt, press the
key.
BREWUNIT BLOCKED
GRINDER BLOCKED
• Contact an authorised customer service center.
To Next Page
Loading...