Heat pump water heater – TECHNICAL INFORMATION FOR INSTALLERS
38
Maximum height difference between
external unit and refrigerant gas pipe
connections (external unit under external
unit)
Quantity of R134a refrigerant fluid
Quantity of fluorinated greenhouse gases
Max. Water temperature with heat pump
Heating time with heat pump (
A
)
Heating energy consumption (
A
)
Max. Amount of hot water in a single
intake V
max
(
A
) delivered at 50°C
Mixed water at 40°C V40 (
B
)
Annual electricity consuption (average
climatic condition) (
B
)
Indoor sound power level (
C
)
Outdoor sound power level (
C
)
Voltage / max. power consumption
220-240 single-phase / 2500
(A) Values obtained with external air temperature of 7°C and relative humidity at 87%, inlet water temperature of 10°C and set
temperature of 50°C (according to the provisions set forth in EN 16147).
(B) Values obtained with external air temperature of 7°C and relative humidity at 87%, inlet water temperature of 10°C and set
temperature of 50°C (according to the provisions set forth in 2014/C 207/03 - transitional methods of measurement and
calculation).
(C) Values obtained from average results of three tests carried out with external air temperature of 7°C and relative humidity at
87%, inlet water temperature of 10°C and temperature set according to the provisions set forth in 2014/C 207/03 - transitional
methods of measurement and calculation and EN 12102).
(D) Outside the operating temperature range of the heat pump, heating of the water is ensured by the integration.
Data collected from a significant number of products.
Additional energy data are shown on the Product Sheet (Attachment A) that is an integral part of this manual.