Need help?Do you have a question about the Ariston RD11s and is the answer not in the manual?
General| Drive Method | Belt drive |
|---|---|
| Speed Control | Manual |
| Output | RCA |
| Type | Manual |
| Motor | AC Synchronous |
| Speeds | 33 1/3 and 45 RPM |
| Platter | Aluminum |
Critical to avoid dust in the main bearing and use the red sealing plug.
Place plinth assembly, remove suspension clamps, plug, and bands.
Fit drive hub gently into bearing and install drive belt on pulleys.
Connect supply cable to amplifier or mains, note tone arm outlet type.
Ensure earth wire is relocated and the unit is level in its mounting for proper function.
Mount tone arm, then level and centralize the board as per Section 4.
Always adhere to the manufacturer's instructions when fitting the cartridge.
Steps for removing headshell, connecting leads, and fitting cartridge securely.
Adjust arm height carefully to ensure stylus does not strike components.
Balance the arm and set tracking weight using the calibrated knob.
Use appropriate weights and positions on the graduated bar for stylus pressure.
Lists essential parts whose damage causes turntable malfunction.
To Next Page