EasyManua.ls Logo

Ariston WDL 862 - Care and maintenance; Cutting off the water and electricity supplies; Cleaning the washer-dryer

Ariston WDL 862
84 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
12
GB
Care and maintenance
Cutting off the water and electricity
supplies
Turn off the water tap after every wash cycle. This will limit
wear on the hydraulic system inside the washer-dryer and
help to prevent leaks.
Unplug the washer-dryer when cleaning it and during all
maintenance work.
Cleaning the washer-dryer
• The outer parts and rubber components of the applian-
ce can be cleaned using a soft cloth soaked in lukewarm
soapy water. Do not use solvents or abrasives.
• The washer-dryer has a “Auto Clean” programme for its
internal parts that must be run with no load in the drum.
For maximum performance you may want to use either the
detergent (i.e. a quantity 10% the quantity specified for lightly-
soiled garments) or special additives to clean the washer-
dryer. We recommend running a cleaning programme every
40 wash cycles.
To start the programme press buttons A and B simultaneou-
sly for 5 seconds (see figure).
The programme will start automatically and will last approxi-
mately 70 minutes. To stop the cycle press the START/PAU-
SE button.
Cleaning the detergent dispenser drawer
Remove the dispenser by
raising it and pulling it out
(see figure).
Wash it under running wa-
ter; this operation should be
repeated frequently.
Caring for the door and drum of your
appliance
Always leave the porthole door ajar in order to prevent
unpleasant odours from forming.
Cleaning the pump
The washer-dryer is fitted with a self-cleaning pump which
does not require any maintenance. Sometimes, small items
(such as coins or buttons) may fall into the pre-chamber
which protects the pump, situated in its bottom part.
! Make sure the wash cycle has finished and unplug the
appliance.
To access the pre-chamber:
1. using a screwdriver,
remove the cover panel on
the lower front part of the
washer-dryer (see figure);
2. unscrew the lid by rota-
ting it anti-clockwise (see
figure): a little water may
trickle out. This is perfectly
normal;
3. clean the inside thoroughly;
4. screw the lid back on;
5. reposition the panel, making sure the hooks are securely
in place before you push it onto the appliance.
Checking the water inlet hose
Check the inlet hose at least once a year. If there are any
cracks, it should be replaced immediately: during the wash
cycles, water pressure is very strong and a cracked hose
could easily split open.
! Never use second-hand hoses.
1
2
A
B

Table of Contents

Related product manuals