Chapter 3: Configuration and commissioning
56 2X-A Series Installation Manual
Notes on day and night mode settings
Day/night mode may be configured to change with a remote input. Depending on
the installation settings, the system may be configured to use an external input to
override the day/night mode setting until the following programmed change (if
any).
Control panels in the same network can have different day/night mode sensitivity
settings.
If the command filter is configured accordingly, a control panel can operate a
local day/night mode setting independently from other control panels in the same
network. A local day/night mode setting is indicated on the local control panel
LCD by the corresponding icon. See “Icons displayed on the LCD” on page 13.
If the control panel is a repeater, remember that the day/night mode displayed
corresponds to those control panels configured to accept the global sensitivity
mode command. Some control panels in the network may be operating with
locally-defined sensitivity settings.
The day/night mode setting for all control panels in a fire network is included in
the Firenet status report.
For more information on the global controls, see “Global controls” on page 73.
To Next Page
Loading...
Need help?
General
