Arkbird
>Switch 9 times(yellow on/blue off ) - set the custom mode to Hover mode;( regard
the hover position as balance position)
>Switch 10 times(yellow off/blue on )-set the custom mode to Semi-balance
mode;( When the CH1 and CH2 of rocker is less than 50%, the plane is in Balance Mode. When
the rocker is more than 50%, the plane is in Gyro Mode.)
>Switch 11 times(yellow on/blue off ) - effective when connecting to PPM or SBUS,
activate the 4th channel steering correction function:
If enabled, the fourth channel will lock the direction and generate a continuous rudder when
moving the nose (please connect to the steering wheel servo). It can be disabled by setting the
input of the CH 7 channel (which is considered to be the landing gear channel) to high.
>Switch 12 times(yellow off/blue on )- enter Neutral point alignment;
More than 12 times, both lights remain on and exit the setting.
5. Manual Mode
Radio Stick and SUB-TRIM back to center, set radio travel range as 100%.
Switching to Manual Mode, Arkbird will not participate control, set manual control’s reverse
through radio, adjust plane’s CG and travel angle.
6. Reverse Balance Mode assistant Control
Switching to Balance Mode, by pushing CH5 to 100% and CH6 to 0%, if the neutral point is
correct, rudder, aileron and elevator shall be at the neutral position, otherwise please check the
neutral point again.
To Next Page
Loading...
