Telescoping pole extends upward from
17 inches to 29 inches.
Compatibility:
Fits smartphones with cases weighing
up to 2 pounds and measuring up to
3.9” wide.
IMPORTANT:
Do not overtighten ring. Overtightening
ring may damage threads on holder
and also make it difficult to adjust
holder.
3 4
2
Insert pole into base.
Your Pro Stand will arrive in five pieces:
Telescoping Pole
Overhead Arm
Assembly
25mm to 1/4”-20
Camera Bolt Adapter
(optional)
Weighted Base
with Allen Wrench
1
MG005WR
Attach overhead arm assembly by unscrewing the collar at the top of
the pole until the metal ball side of the overhead arm assembly fits
into the collar. Tighten collar clockwise to secure.
Unscrew tightening ring from holder. Place ring over the 17mm end of
mount then snap the holder onto the ball. Set to desired position, then
tighten ring.
Using two hands, insert phone into the holder by pushing the device
into one of the spring-loaded support arms. Expand the other support
arm and fully insert device.
SP25MMCAM
Assembled Mount
SP3RMPROPL
SPHD8BASE
SP3RMPR0PL
SPHD8L29
Tighten clockwise
to secure.
Tightening Ring
Telescoping
Pole
Allen
Wrench
Continued on page 2
HD8RV29 | Arkon Pro Stand for Phones, Cameras, or Pico Projectors
rev.021022
SPHD8L29
SPHD8BASE
Phone Holder
MG005WR
Attach overhead arm assembly by unscrewing the collar at the top of
the pole until the metal ball side of the overhead arm assembly fits
into the collar. Tighten collar clockwise to secure.
Tightening
Knob
Collar
Metal
Ball side
To Next Page
Need help?
General
