7
TROUBLESHOOTING
Unit does not operate
Is the unit plugged in?
Is the power outlet switched on?
Is the Full Water indicator on?
(If so empty the condensed water)
Unit does not seem to cool effectively
Is the room too large?
Is there direct sunlight onto the unit?
(close curtains and pull down blinds)
Are windows or doors open?
Is there another heat source in the room?
Is the filter dusty or contaminated?
Is the air intake blocked?
Is the outlet duct venting the hot air
properly?
Is the room temperature below your
selected temperature?
Too Noisy
Is the unit positioned on an uneven hard
floor surface creating vibration?
Note: A soft carpeted surface may absorb
excessive vibration
The Compressor does not operate
Has the overheating protective device
operated? If so allow time for the
compressor temperature to decrease.
The device will automatically reset
Important Note: This unit is built in
accordance with relevant safety and
performance standards. An electrical
specialist must carry out repairs.
SPECIFICATIONS
Input power consumption :
1000 watt (1.3 horsepower)
Cooling capacity :
9000 BTU/hr (2600 watt)
Air volume moved at max. fan setting:
360 cubic metres/hr
CPIN_518-2 15/9/04 5:08 PM Page 7
To Next Page
Loading...
Need help?
General
