4
FREE STANDING
1. Ensure the heater is unplugged and power switches are off.
2. Set heater upside down.
3. Locater four holes at each end of the base of the heater.
4. Secure the foot plates to the base using the shorter screws provided.
5. Attach 2 castors to each foot plate securing them using a spanner.
6. Set heater upright and plug into a standard 230/240 volt AC electrical outlet.
WALL MOUNTED
1. Ensure the heater is unplugged and the power switches are off.
2. Position heater within one metre of a wall socket.
3. Detach the mounting bracket from the back of the panel heater by unscrewing
the 2 locking screws located on the top of the mounting bracket, and press
down on the 2 release tabs.
4. Position the mounting bracket on the wall and mark the hole positions with a
pencil and check they are horizontal with a spirit level. Ensure the two bottom
mount holes are at least 300mm from the floor and drill holes as required.
5. Secure the mounting bracket to the wall with the 4 longer mounting screws.
For masonry walls, use the plastic wall plugs provided.
6. Slot the back of the heater onto the mounting bracket locating the bottom
hooks first and secure by tightening the two locking screws.
Check the panel heater is secure on the wall.
7. Plug into a standard 230/240 volt AC electrical outlet.
When slotting the panel heater onto the
wall mounting backet, locate and align
slot ‘A’ with point ‘a’ first and slot ‘B’ with
point ’b’
A
A
B
B
a
b
a
b
Mounting Screws
Locking Screws
PEH002 Instructions.indd 4 22/12/09 2:30:11 PM
To Next Page
Loading...
Need help?
General
