• Senses movement within 1 metre
distance and illuminates for
approximately 30 seconds when
triggered.
• 9 Super Bright LED Modules.
• 360° Swivel head.
• Ideal for undercabinet lighting,
bedrooms, kitchens, basements,
attics and wardrobes.
• Easy installation using attached
mounting bracket for wall or
undercabinet mounting.
• Requires only 3 x AA batteries
for operation.
• No bulbs to replace
Mounting bracket is attached to the
rear of the swivel light. Simply fix 2
screws into mounting surface then
slide the mounting bracket over
screws to lock into position.
Rotate light to expose battery cover.
Lift battery cover and insert 3 x AA
batteries with polarity as marked.
See Figure 1.
Fe atUre s InstallatIon
The push button switch turns light
on and off. When initially turned
on the light will stay illuminated
for approximately 30 seconds if no
movement is detected.
The sensor will detect movement
within approximately 1 metre and
remain illuminated for approximately
30 seconds if no further movement
is detected.
32
Figure 1.
BatterY InstallatIon
operatIng InstrUCtIons
Screw
Push Button Switch
Sensor
• This product is designed for indoor
use only.
• Not for use in wet or damp locations .
• Batteries may leak harmful liquids
or ignitable materials or explode
causing injury or damage.
• Do not mix old and new or any
battery types.
• Replace all batteries at the same time.
• Replace fully discharged batteries
immediately.
• Remove batteries if light is unlikely
to be unused for extended periods.
• Switch off before cleaning.
• Clean the exterior with a damp
cloth, then wipe dry.
• Do not use abrasive cleansers
or solvents.
Care anD CleanIng
saFetY InFormatIon
Screw
To Previous Page
Loading...
