Arm's Reach Co-Sleeper Versatile - How to Assemble Sleeping Nest; How to Assemble Bassinet

How to assemble Sleeping nest
Step 1
Step 2
4
How to assemble bassinet
Step2:Connecting Left and Right brackets
(D & F) with Nest supporting bar (E) and
Foot stabilizing bar (G)
WARNING: DO NOT use Sleeping nest
separately .
D
F
I
I
Step 1 To assemble the Telescoping foot (I)
into Left and Right brackets (D &F)
:
D
F
I
E
G
I
PRESS
Fig 1.
Fig.2
Side bar
Pin
Push the Telescoping foot (I) into the Left and Right
brackets (D & F).When the red pin clicks, it's locked.
Place Sleeping nest upside down. Pull the side
bars upright.
Slide the plastic holders on bottom of the nest into
the opening of side bars. Plastic holder will click
when locked Repeat on the second side.You will
need to pull the sleeping nest holder on the second
side to lock into side bar.
.
The Sleeping nest is assembled.
Align the dent on the end of Nest supporting bar (E)
with the Left bracket (D) as Fig.1. Press down on the
spring pin located on the Left bracket (D) as Fig.2.
Push the Nest supporting bar (E) over the spring pin
until the spring pin is locked. Now connect the Foot
stabalizing bar (G) to the Left bracket (D). Repeat
process to connect the Right bracket (F).