10
INSTALLING & CLEANING REUSABLE CLOTH FILTER
INSTALLING & CLEANING FOAM WET FILTER
1 2 3 4 5
1 2 3 4 5
Installing Reusable Cloth Filter
1. Verify that the power cord is disconnected from the outlet. (g. 1)
2. Remove the power head and place it in an upside-down position.
3. Slide reusable cloth lter down over the lter cage making sure the cage is completely covered. (g. 2 & 3)
4. Replace the power head onto the collection tank.
Removing and Cleaning Reusable Cloth Filter
1. Remove the power head and place it in an upside-down position.
2. Carefully remove the reusable cloth lter from the lter cage. (g. 4) Clean the lter by gently tapping or brushing dirt
off. Cleaning should not be done indoors in living areas.
3. Use a mild soap and water solution to wash reusable cloth lter and rinse with clean water. (g. 5)
4. Allow the wet lter to air dry for 24 hours before installing onto the lter cage.
Installing Foam Wet Filter
1. Verify that the power cord is disconnected from the outlet. (g. 1)
2. Remove power head and place in upside down position. Follow instructions to remove cloth lter.
3. Carefully slide foam wet lter down over the lter cage, making sure the cage is completely covered. (g. 2 & 3)
4. Replace the power head onto the collection tank.
Cleaning Foam Wet Filter
1. With the removed power head in an upside down position, carefully remove foam wet lter. (g. 4)
2. Use a mild soap and water solution to wash foam wet lter and rinse with clean water. (g. 5)
3. Allow lter to air dry before installing and using again.
NOTICE! The lter included is made of high quality material designed to stop small dust particles. The lter should be
used for dry pick-up only. A dry lter is necessary to pick up dust. If the dust lter is wet, it will clog quickly and be very
difcult to clean. Handle the lter carefully when removing it for cleaning and replacing it. Check the lters for tears or
small holes. A small hole can let dust pass through the lter. Do not use a lter with holes or tears; replace it immediately.
WARNING:
ALWAYS DISCONNECT THE PLUG FROM THE POWER OUTLET BEFORE REMOVING THE POWER
HEAD FROM COLLECTION TANK.
To Next Page
Loading...
