6
GENERAL ASSEMBLY INSTRUCTIONS
UNPACKING YOUR WET/DRY VACUUM & GENERAL ASSEMBLY
1. Verify that the power cord is disconnected from the outlet. (g. 1)
2. Undo the latches. (g. 2)
3. Lift the power head off the collection tank. (g. 3)
4. Remove the contents from inside the collection tank. Make sure you have all contents as listed on page 5. (g. 4)
5. For dry vacuum cleaning, install the supplied reusable cloth lter. (g. 5) For lter installation instructions, see page 10.
6. For wet vacuum cleaning, install the supplied foam lter. (g. 6) For lter installation instructions, see page 11.
7. Place the power head back on the collection tank, aligning the top section with the latches, and snap into place. (g. 7
& 8)
8. Insert the larger end of the hose into the desired port. (g. 9)
9. Choose the desired accessories and insert onto the end of the hose. (g. 10)
POLARIZED PLUG
To reduce the risk of electrical shock, this appliance has a polarized plug (one blade wider than the other). This plug will t
in a polarized outlet only one way. If the plug does not t fully in the outlet, reverse the plug. If it still does not t, contact
a qualied electrician to install the proper outlet. Do not change the plug in any way. Double insulation eliminates
the need for the three wire grounded power cord and grounded power supply system.
1 2 3 4 5
6 7 8 109
WARNING:
DO NOT PLUG POWER CORD INTO POWER OUTLET, MAKE SURE PLUG IS DISCONNECTED
BEFORE ASSEMBLING THE WET/DRY VAC.
To Next Page
Loading...
