507296-01 Page 1 of 13Issue 1650
THIS MANUAL MUST BE LEFT WITH THE
HOMEOWNER FOR FUTURE REFERENCE
Installation and servicing of air conditioning equipment
can be hazardous due to internal refrigerant pressure
and live electrical components. Only trained and
qualied service personnel should install or service
this equipment. Installation and service performed by
unqualied persons can result in property damage,
personal injury, or death.
WARNING
For your safety, do not store or use gasoline or other
ammable vapors and liquids in the vicinity of this or any
other appliance. Such actions could result in property
damage, personal injury, or death.
WARNING
The installation of this appliance must conform to the requirements of the National Fire Protection Association; the
National Electrical Code, ANSI/NFPA No. 70 (latest edition) in the United States; the Canadian Electrical Code Part
1, CSA 22.1 (latest edition) in Canada; and any state or provincial laws or local ordinances. Local authorities having
jurisdiction should be consulted before installation is made. Such applicable regulations or requirements take precedence
over the general instructions in this manual.
CAUTION
Save these instructions for future reference
INSTALLATION AND MAINTENANCE
INSTRUCTIONS
*RP14AC AND *RP14HP SERIES
UNITS
RESIDENTIAL PACKAGED UNITS
Air Conditioners and Heat Pumps
507296-01
12/2016
Table of Contents
Installation ...................................................................2
Electrical Wiring ...........................................................4
Duct System ................................................................5
Filters ...........................................................................5
Condensate Drain........................................................5
Sequence of Operation................................................7
Maintenance ................................................................9
Wiring Diagrams ........................................................10
If this unit is to be installed in a mobile or manufactured
home application, the duct system must be sized to
achieve static pressures within the manufacturer’s
guidelines. All other installation guidelines must also
be followed. Failure to do so may result in equipment
damage, personal injury, and improper performance of
the unit.
WARNING
See Unit Nameplate for Manufacturer
*P507296-01*
(P) 507296-01
To Next Page
Need help?
General
