073
®
Designed in Sweden© Arozzi Europe AB. 2024
ARENA MOTO
Operations Manual
Display
Up
Down
Set Memory
Save 1
Save 2
Save 3
Save 4
Up/Down operation
Wake up controller
Position memory
Setting a minimum height
• Press the Up button until you reach your desired height. The operation stops when reaching the
highest possible point.
• Press the Down button until you reach your desired height. The operation stops when reaching the
lowest possible point.
• Short-press Up or Down and the display will show current height and react to further input
• You can save up to four positions corresponding to the save buttons (1, 2, 3, 4). Save the current
position by pressing the M key and then your prefferred save button.
• You can see previously saved positions by short-pressing any save button. The display will then show
the saved height.
• Double click or long press any of the save buttons (1, 2, 3, 4) and the desk will move to the
corresponding position.
• To set the current height as minimum height for the desk, hold down both Down + M buttons until the
display shows ”-do” indicating that the minimum height has been stored. Storing a minimum height
ensures that the desk never goes below this position.
• To delete the saved minimum height, let the desk run downwards until it stops. Press down again and
the display shows ”-Lo”. Then hold down Down + M buttons until the display shows ”-do” indicating
that the stored minimum height has been deleted.
To Next Page
Need help?
General
