Array Solutions AS-SAL-12 Mark II - Page 6

Array Solutions - SAL12/20/30 - Mark II Manual – Rev. 1.5.1 – September, 2018
6
SAL-20 Mark II Package Contents
SAL-20 Mark II Antenna Material List
QTY
ITEM
1
Aluminum 22 ft mast kit with hardware
14
2" x 1/4"-20 bolts with safety hex nuts
3
6 ft (1.83 m) 1-1/2" (38.1 mm) OD aluminum tubing
1
4 ft (1.83 m) 1-1/2" (38.1 mm) OD aluminum tubing (double wall)
2
Tie-down “D” rings with plates for ¼” bolts
2
Insert coupling 1-3/8" x 7" (31.75 mm x 182 mm) aluminum insulator
1
Insert coupling 1-3/8" x 3-1/2" (34.9 mm x 88.9 mm) aluminum tubing
1
Insert coupling 1-1/4" x 7" (31.75 mm x 182 mm) fiberglass insulator
8
Solder eye lugs for 1/4" bolts (attached to cable loops)
4
44' (10.36 m) cables for loops (with TX line, coupler, and solder lug)
4
Anchoring Stakes
40
ft of rope to cut as follows*: 4 x 10 ft (3.05 m) guying ropes.
2
Hose clamps 2"
1
PVC Mast base with 4” pipe inserted
4
Couplers with 10 ft (3.05 m) 120 ohm TX lines (attached to the loops)
4
Guy rope tensioners
1
11 ft (3.35 m) RG-6 coaxial cable delay line with F connectors attached
1
Control Switch
1
Combiner/Pre-amp
1
15v Power supply
*
Suggested cutting lengths may vary depending on site's topography.