Array Solutions AS-SAL-12 Mark II - Page 7

Array Solutions - SAL12/20/30 - Mark II Manual – Rev. 1.5.1 – September, 2018
7
SAL-30 Mark II Package Contents
SAL-30 Mark II Antenna Material List
QTY
ITEM
1
Aluminum 30 ft mast kit with hardware
22
2" x 1/4"-20 bolts with safety hex nuts
5
6 ft (1.83 m) 1-1/2" (38.1 mm) OD aluminum tubing
1
4 ft (1.83 m) 1-1/2" (38.1 mm) OD aluminum tubing (double wall)
2
Tie-down "D" rings with plates for 1/4" bolts
4
Insert couplings 1-3/8" x 7" (34.9 mm x 182 mm) aluminum tubing
1
Insert coupling 1-3/8" x 3-1/2" (34.9 mm x 88.9mm) aluminum tubing
1
Insert coupling 1-1/4" x 7" (31.75 mm x 182 mm) fiberglass insulator
8
Solder eye lugs for 1/4" bolts (already attached to the loops)
4
65' (19.81 m) cables for loops (with TX line, coupler, solder lugs attached)
8
Anchoring Stakes
180
ft of rope to cut as follows: *
4
10 ft (3.05 m) guying ropes for outer stakes
4
35 ft (10.67 m) guying ropes for inner stakes
2
Hose clamps 2"
1
PVC Mast base (with 4” pipe inserted)
4
Couplers with 17 ft (5.18 m) 120 ohm TX lines (attached to the loops)
8
Guy rope tensioners
1
21.75 ft (6.55 m) RG-6 delay line (with F connectors attached)
1
Control Switch
1
Combiner/Pre-amp
1
15v Power supply
*
Suggested cutting lengths may vary depending on site's topography.