5
Installing a DCT700 Digital Adapter
1. Connect the coax wire from the wall outlet to the COAX IN port on the DCT700 Digital
Adapter.
2. Connect the 2nd coax cable from the COAX OUT port on the DCT700 Digital Adapter to the
TV coax port.
Note: RCA cables R/W/Y (not provided) could be used in lieu of coaxial cables from the
adapter to the TV.
3. Connect the power adapter cable to the DCT700 power port.
4. Plug the power adapter cable into the electrical outlet.
5. Use the remote control to power on the device.
6. Contact Frontier to activate the device at 1.866.739.4319.
To Next Page
Loading...
