Arrow Auntie 900 - Cabinet Assembly Procedures; Frame Construction and Initial Assembly

180°
Assembly Instructions
Auntie Sewing Machine Cabinet Page 3
Understanding How the “ARROW-LOC” Cam Fastener Works
Cabinet Assembly
Position bolt in
pre-drilled hole and
turn until tight.
Press cam Into pre-drilled
hole until flush with surface.
Insert bolt through pre-drilled
hole in edge of panel.
To lock, rotate cam
until tight, using
screwdriver.
ARROW TOWARDS
HOLE IN EDGE!
FIG. 1A
FIG. 1
Partition
(viewed from left)
Partition
(viewed from right)
Step 1. Place Top (A, B, C), Partition (F) and Left
and Right Sides (G & H) on a flat protected surface
to prevent scratches. Thread connecting bolts (21
total) into pre-drilled holes (as shown in FIG. 1
and above). Turn Partition (F) over and thread in
the remaining bolts as shown in FIG. 1A.
Connecting Bolts x21
C
H
G
F
F